Development Tools

Debug Manager panel

When the selected microcontroller is the multi-core product, this panel is used to select a core (PE: Processer Element) to be debugged and display the core status (see "2.9 Select a Core (PE)").

This panel appears only when connected to the debug tool.

Caution

This panel cannot be opened when the selected microcontroller is the single-core product.

Figure A.3

Debug Manager Panel

This section describes the following.

-	[How to open]

-	[Description of each area]

[Toolbar]

[How to open]

-	From the [View] menu, select [Debug Manager].

[Description of each area]

(1)	[Selects debug target core] area

Select a core (PE) to be debugged with a option button.

Remark 1.

[Simulator]

This area becomes invalid during execution of a program.

Remark 2.

You can also select a core to be debugged on the statusbar in the Main window.

(2)	[Debug target core status] area

This area displays the status of the core currently being selected.

Remark

You can also confirm the information displayed in this area on the statusbar in the Main window.

(a)	[Running status]

Displays the current state of the program with the following icons and character strings.

State of Program	Displayed Content
Running	RUN
Stopped	BREAK
In step execution	STEP

(b)	[Core status]

Displays the current core statuses of the debug tool. When there is the possibility that the core is in two or more statuses, the corresponding display contents are displayed separated by "&".

Debug Tool	Displayed Content	Core Status
Full-spec emulator E1/E20	Halt	In HALT mode
	Stop	In STOP mode
	Reset	In reset state
	Pow Off	Power not supplied to the target
	Initial Stop	In initial stop state
	Deep Stop	In Deep Stop mode
	Cyclic Run	In Cyclic Run mode
	Cyclic Stop	In Cyclic Stop mode
	Cyclic Disable	This is the state of the core other than the main core when the main core is in the Cyclic Run or Cyclic Stop mode.
	Standby	A clock signal is not being supplied to the GTM.
	Disable	The selected multi-channel sequencer (MCS) is not activated.
Simulator	Halt	In HALT mode
	Stop	In STOP mode
	Reset	In reset state

(c)	[Current PC]

Displays the current PC position with a hexadecimal value. When this button is clicked, the caret moves to the current PC position on the Editor panel.

[Toolbar]

The function of this toolbar is the same as that of the Debug toolbar on the Main window. For details on the function of each button, see "(2) Debug toolbar".